How to Install an Ethernet Exterder without a Splitter | VX-VEB160G4

The VX-VEB160G4 is an Ethernet Extender that achieves data rates of up to 300 mbps via legacy copper lines. Follow this tutorial to setup your devices.

1. First, you will need to setup one of your Ethernet Extenders to operate as the Source unit.
2. Power on both units by connecting the power adapters into the wall.
3. Then, connect the power to one of your Ethernet Extenders from your Ethernet Extender Kit.
4.  Plug the Ethernet cable into any of the ports on the back of the Unit. Connect the same Ethernet cable to your Ethernet Switch.
5. To Set your device to operate as a source, flip the dip switch to OT or office terminal mode. The RT LED indication will turn off.
6. Then connect your telephone cable to the wall.
7. Connect the adjacent side of your telephone cable to the VDSL2 interface located on the front of the unit.

You will then need to setup your remaining Ethernet Extender to operate as the destination unit. TO set the device to operate as the destination, flip the dip switch to RT or Remote Terminal mode. The LED RT indicator will turn on.

1. Plug your Ethernet cable into any of the ports on the back of the unit.
2. Plug the adjacent side of the Ethernet cable to your powered device such as a wireless access point.
3. Connect your telephone cable to the VDSL2 interface located on the front of the unit. Connect the adjacent side of your telephone cable to the wall. The link light will continuously flash and turn solid once it successfully synchronizes with the other unit.

For more information on the VX-VEB160G4 click here