The VX-VEB160G4 is an Ethernet Extender that achieves data rates of up to 300MBPS via legacy copper lines. Follow this tutorial to setup your devices.
- First, you will need to setup one of your Ethernet Extenders to operate as the Source unit.
- Power on both units by connecting the power adapters into the wall.
- Then, connect the power to one of your Ethernet Extenders from your Ethernet Extender Kit.
- Plug the Ethernet cable into any of the ports on the back of the Unit. Connect the same Ethernet cable to your Ethernet Switch.
- To set your device to operate as a source, flip the dip switch to OT or office terminal mode. The RT LED indication will turn off.
- Then connect your splitter to the wall and connect your 160G4 to the modem port on the splitter.
- Connect your phone system or handset to the phone port on the splitter.
You will then need to setup your remaining Ethernet Extender to operate as the destination unit.
- To set the device to operate as the destination, flip the dip switch to RT or remote Terminal mode. The LED RT indicator will turn on.
- Plug your Ethernet cable into any of the ports on the back of the unit.
- Plug the adjacent side of the Ethernet cable to your powered device such as a wireless access point.
- Then connect your splitter to the wall and connect your 160G4 to the modem port on the splitter.
- Connect your phone system or handset to the phone port on the splitter. The link light will continuously flash and turn solid once it successfully synchronizes with the other unit.
To learn more about the VX-VEB160G4 click here
Comments
0 comments
Please sign in to leave a comment.